What parts need to be replaced during maintenance of WPS60-60-B worm gear reducer

During routine maintenance and overhaul of WPS60-60-B, it is necessary to replace "lubricating oil, seals, and grease" on a periodic basis, and decide whether to replace core components such as "worm gear, bearings, gaskets, O-rings" based on the test results.
Routine maintenance (parts must be replaced)

Lubricating oil: replace the new machine after 300-500 hours; Replace every 1500-2000 hours or 6 months thereafter, and different brands and models must not be mixed.

Input/output shaft oil seal (skeleton oil seal): Replace if leakage or aging is found, and install to avoid lip damage.

Bearing grease: When disassembling or inspecting bearings, supplement or replace them with suitable high-temperature resistant and anti-wear grease.

Dismantling/overhaul (replace according to inspection)

Worm gear and worm gear: If the tooth thickness wear is ≥ 10%~15%, or if there is pitting/bonding to a certain extent, they are usually replaced in pairs; There are slight differences in the description of "replacement threshold" among different materials. It is recommended to refer to the actual measurement and manufacturer's manual for accuracy.

Bearings: Replace when there is abnormal noise, overheating, excessive clearance, or abnormal vibration; Priority should be given to using high-precision bearings of the same model.

Gasket/O-ring for box joint surface: Disassemble and replace to ensure reliable sealing.

Ventilation cap/respirator: Replace regularly depending on the degree of contamination to maintain smooth ventilation.

Oil drain plug and sealing ring: Check every oil change and replace if necessary to prevent leakage.